Westerbeke WPDS-20 Instrukcja Operatora Strona 41

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 114
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 40
As indicated above, operate the engine in moderation during the 50-hour break-in period. (On one hand
don't
baby the engine, but on the other hand, however,
don't
abuse it.)
Starting
Under
Normal
Conditions
Follow the procedure below for normal starting of the engine:
1.
Check the engine and transmission lubricant levels and fill, if necessary.
2.
Make sure there
is
sufficient fuel on board. Keep fuel tank(s) as full as possible. Check the fuel filters
and water separators for the presence
of
contaminants and/or water. Drain and clean them as needed.
3.
Check the coolant level in the plastic recovery tank. Add coolant solution as needed.
NOTE: Excessive loss
of
coolant from the plastic recovery tank indicates a cooling system
leak. Check the entire
cooling system and the recovery tank and its connections at the ex-
haust manifold, and pressurize the system
to
locate the leak. In cases
of
excessive coolant
loss, the system must be refilled as
outlined under the "PREPARATION FOR STARTING" sec-
tion
of
this manual, page
22.
4.
Check for all and fuel leaks, particularly if signs
of
such leaks are found on the bottom
of
the engine or
below the engine.
5.
When checking your engine's coolant and all levels, check the engine
for
any
noticeable abnormalities
such as loose
or
missing bolts, loose brackets and mounts, loose hose clamps, chafed wires,
or
any
other components that exhibit wear
or
are loose.
Start the engine in accordance with the "STARTING PROCEDURE" instructions found on page
26,
and allow
the engine's operating temperature
to
reach 140 - 150· F before operating the engine underway.
29
Westerbeke
Diesel
Engines
Przeglądanie stron 40
1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 113 114

Komentarze do niniejszej Instrukcji

Brak uwag