Westerbeke 38B FOUR Instrukcja Operatora Strona 84

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 108
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 83
MAINTENANCE AND ADJUSTMENTS
Introduction
This section contains a scheduled preventive maintenance program and several adjustment procedures the
owner/operator can perform without the benefit of sophisticated and expensive
tools and instruments.
Preventive
Maintenance
Perform the preventive maintenance in accordance with the schedules listed
in
the following paragraphs.
Adherence
to
these schedules will ensure the equipment is maintained in the best possible condition and
that it will perform
to
expectations. Those items marked
by
an
asterisk
(*)
are recommended
to
be per-
formed
by
an authorized dealer or distributor.
Daily
(before
each
use)
1.
Check the oil sump level. Maintain the oil level at or near upper level mark on dipstick.
2.
Check the coolant level
in
the plastic recovery tank. Maintain this level at
or
above the level marked
ADD.
3.
Check the transmission's lubricant level, and add additional lubricant as needed.
4.
Visually inspect the unit; check for loose belts, chafed or broken wires, loose brackets and fittings,
damaged hoses,
loose clamps, and other equipment not properly secured. This check should include
the
propeller shaft coupling
to
the transmission's output flange.
5.
Check the fuel supply. Fill tank(s) with a good grade
of
No.2
diesel fuel, if required.
6.
Check the primary filter/water separator. Drain and service as required.
(A
primary filter/Water separator
is
optional, but strongly recommended.)
7.
Check the engine's gauges
or
lights for proper oil pressure, operating temperature, and starting bat-
tery charging
voltage once the engine
is
operating.
8.
Check the alternator's output gauge (if installed) for proper DC voltage.
9.
Check to make sure the propeller shaft
is
securely connected
to
the transmission coupling.
Monthly
Check the condition
of
the zinc anode
in
the heat exchanger's
sea
water circuit. Clean or replace the anode,
as required. Keep the area inside the heat exchanger clean of zinc anode debris.
Westerbeke
Diesel
Engines
82
Przeglądanie stron 83
1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 107 108

Komentarze do niniejszej Instrukcji

Brak uwag