Westerbeke 4.5 KW BGC -60Hz Instrukcja Operatora Pobierz pdf (Strona 36)

PREPARATIONS FOR STARTING

This section

the manual provides the operator with preparation, initial starting, break-in, starting (cold

warm), and stopping procedures. Follow the procedures as presented,

for

the conditions indicated, and

your Westerbeke generator set will give you

reliable performance and long service life.

Take the steps described below

starting your engine for the first time

after a prolonged shutdown

lay-up.

Fill your engine with oil up

but not over the upper limit on the

dipstick (the installation

angle of your generator set may have

an effect on the dipstick reading).

Select a readily available

lubricating oil with an

API

specification

SD,

SF and an

SAE number suitable

forthe

temperature in your operating area

(see page

54).

Forthe

quantity

oil needed in your generator's

engine,

referlo

the "SYSTEM SPECIFICATION" section

this

manual, page

for

the BCG 4.0KW, and page 16

for

the

BCG

6.5KW.

Each unit is supplied with a coolant recovery

ktt

(part

#24977)

as standard equipment, to which the following applies:

upp

LIM! T

(NORMRL

LEVEL)

LOWER

LIMIT

A. Remove the pressure cap from the engine's exhaust manifold and slowly fill the engine's cooling sys-

tem with a mixture

water and antifreeze suitable for your temperature zone. (See the "COOLING

SYSTEM"

section

this manual, page 49.) Replace the pressure cap on the manifold.

B. Make sure the plastic recovery tank

properly mounted near the unit (with the bracket provided) in a

location where it can be monitored and

filled easily (see page 49). The recovery tank should be mounted

at manifold

level

above.

Coolant should be added

the plastic recovery tank after the engine has been filled and started. After

its operating temperature has been reached, make sure

all air

expelled out

the engine's manifold

and the engine's cooling system. With the manifold filled and the pressure cap

installed, fill the plastic

recovery tank

half full. Monitor this recovery tank daily and add coolant as needed.

Fill the

fuel tank with unleaded or leaded gasoline that has an octane rating

89 or higher.

Make sure the

Installation Checks have been made in accordance with those specified in the "INSTALLA-

TION CHECKS"

section

this manual (refer

page 18) and that there

no AC load on the generator.

Westerbeke Generators

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 94 95

Komentarze do niniejszej Instrukcji

Brak uwag

Westerbeke 4.5 KW BGC -60Hz Instrukcja Operatora Strona 36

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Silnik Westerbeke 4.5 KW BGC -60Hz